Page 51

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

REQUIRED FOR A SUCCESSFUL REFILL:

Toner (Uni-Kit Formula 1A)

1 funnel cap

1 hole plug

Toner Hole Making Tool

General Refilling Procedures:

Rest the Hole Making Tool on its stand and plug into an outlet. Wait 3 full minutes

before using. Position the copper bit on the cartridge in the spot indicated by the photo-

graph and push gently until it melts a hole in the cartridge. Please note that you will also

be putting a hole not only in the cover but the internal cover as well.s Remove the tool,

place it back on its stand and unplug it. If the small piece of plastic has fallen into the

cartridge, it must be removed, as this can damage your cartridge or cause print defects.

If the piece remains in the tool, wait for the tool to cool down and pry it out.

Before opening the bottle of toner, turn it upside down and tap it on a table to loosen the

toner and allow it to flow freely. Remove the cap and pull the seal off the bottle. Attach

the funnel cap making to sure it is on tightly. Tilt the funnel cap toward the filling hole

and insert it into the hole. If the toner stops flowing before the cartridge is full, simply

remove the toner, close the cap, turn the bottle upside down and tap it on a table. Once

the cartridge is full seal the hole with the plug.

Do not press down on the plug since the cartridge is resting on a table this can actually

damage the photo-optic drum. Instead hold one end of the cartridge up off the table

and twist the plug until it fully sealed. Now gently shake the cartridge side to side to

distribute the toner.

Ricoh - 339302

Minolta - 17030190000

Lexmark - 140195AX

HP - 92295AX

Canon XS/EPS

Apple-M6002